
Remote Control Commands
74 PM-1100
Product-Specific Commands—Quick Reference
Product-Specific Commands—Quick Reference
The table below contains a summary of th ePM-1100 Optical Power Meter
specific commands. Thes commands are fully explained on the following
pages.
Command
Parameter/
Response
Description
ABOR — Stop continuous
measurements
DISP DIMM <LO|HI|OFF> Set display intensity
DIMM? (LO|HI|OFF) Get display intensity
FETC [SCAL] POW DC? (±999.999E±99) Get stored value
FORM READ [DATA] * <0|1|2|3|4> Set display resolution
[DATA]? * (0|1|2|3|4) Get display resolution
INIT CONT <0|1> Start/stop continuous
measurements
CONT? (0|1) Continuous measure-
ments in progress?
[IMM] — Store single
measurement
STOR <0 to 513> Initialize memory
location
MMEM ACQ <0|1> Start/stop acquisition
Comentarios a estos manuales