
Controlling Your Optical Power Meter Remotely
42 PM-1100
Setting the Optical Power Meter for Remote Control
Setting the Optical Power Meter for Remote
Control
To remotely control the Optical Power Meter, you need to set a GPIB
address or activate the RS-232 port.
To set the Optical Power Meter for remote control:
1. Press Setup.
2. Scroll (left/right arrows) to GPIB-RS.
3. Press ENTER. The current setting will start flashing.
4. Using the up/down arrows, enter a new setting.
³ a numbered setting represents a GPIB address (between 1 and 30)
³ for RS-232 control, scroll (up/down arrows) to RS-232 (before setting 1
or after setting 30).
5. Press ENTER.
6. To exit the Setup menu, press Setup.
Current setting
Comentarios a estos manuales