Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5 Manual de usuario descargar pdf (Pagina 259)

100

101

Test Setup - Test Configurator, Timer, and System

Power Blazer 247

Traces (SONET/SDH)

Note: 16-bytes selection allows typing up to 15 bytes (a CRC-7 byte will be added

in front for a total of 16 bytes). 64-bytes selection allows typing up to

62-bytes (<C

> and <L

> bytes will be added at the end for a total of

64-bytes). Traces values should be ASCII suitable characters including the

ITU T.50 Characters on page 31.

 TIM-S/RS-TIM, TIM-P/HP-TIM, TIM-V/LP-TIM: Enables the

corresponding Trace Identifier Mismatch for the expected message

defined. These settings are coupled with the Result - Traces/Labels

configuration (refer to Traces - SONET/SDH on page 398).

Format: Allows the selection of the expected format:

16 Bytes (default), or 64 Bytes.

Expected: Allows entering the expected J0 trace message for

TIM-S/RS-TIM, J1 for TIM-P/HP-TIM, and J2 for TIM-V/LP-TIM. See

Default values/messages on page 246.

TCM Access Point Identifier

Note: Available when TCM is enabled from the Signal - Signal Configuration

(SONET/SDH) on page 219.

 STS/AU Path (N1), and VT/TU Path (Z6 or N1 (TU-3))

Enter the N1/Z6 value/message to be generated.

 TC-TIM-P/HPTC-TIM/TC-TIM-V/LPTC-TIM: Enables the corresponding

TCM Access Point Identifier for the expected message defined. These

settings are coupled with the Traces configuration from Traces

(SONET/SDH) on page 246.

Copy RX allows to use the received TIM message as the expected one.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 680 681

Comentarios a estos manuales

Sin comentarios

Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5 Manual de usuario Pagina 259

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5