Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5 Manual de usuario descargar pdf (Pagina 230)

100

101

Test Setup - Test Configurator, Timer, and System

218 FTB/IQS-88000 Series

Signal - Signal Configuration (OTN)

 Tributary Port, configurable when the Fixed Structure check box

is cleared, allows to select the Tributary Port number that will be

associated to the selected tributary slots. When the Fixed

Structure check box is selected, the Tributary Port is

automatically assigned to either the selected slot number or for

OPU3 to the first slot number in the column.

 Nominal Bit Rate (Gbit/s) available with ODUflex and

ODUflex/GFP-F indicates the TX frequency based on the number of

tributary slots selected. Note that for ODUflex with pattern Client,

the Nominal Bit Rate may be affected by the TX Rate when not set

to 100% (see TX Rate on page 102).

 Number of Trib Slots indicates the number of tributary slots

selected.

Note: Tributary slots must be selected starting with the higher layer down to the

lower and all required tributary slots must be selected to access the next

level. For example an ODU3/ODU2/ODU1 multiplexed test, requires in order

a group of 4 OPU3, and a single OPU2.

 Config TCM

Allows to enable each TCM level (1 to 6) individually. All ODUx of a

mapped signal are also available. All TCM check boxes are cleared by

default (disabled). Refer to Traces (OTN) on page 243 for more

information.

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 680 681

Comentarios a estos manuales

Sin comentarios

Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5 Manual de usuario Pagina 230

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FTB/IQS-88000 Series Power Blazer for FTB-2/2Pro/5