Exfo AXS-200/850 Ethernet Test Set Manual de usuario Pagina 212

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 262
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 211
Tools
202 AXS-200/850
Cable Test Results - Wire Map
Wire Map Test Result: Gives the wire map test result for each pair.
When the link is up: The wire map result for each pair is given as seen
by the AXS-200/850 to get a link up. This means that the wire map result
may not correspond to the type of cable tested depending on the
cable(s) used and/or the configuration of the cable mode (MDI, MDIX,
or autodetection) on both the AXS-200/850 and the far end equipment.
For example, two crossed pair cables end to end used between the
AXS-200/850 and a far end equipment may give a straight pair (MDI)
wire map result.
MDI: Straight pair.
MDIX: Crossed pair.
MDI (-): For 1Gbps, straight pair with swapped wires within pair.
MDIX (-): For 1Gbps, crossed pair with pair A swapped with pair B
and/or pair C swapped with pair D.
Noise: Excessive noise on a pair most likely caused by a link
partner running in 10/100Mbps forced mode. In this case, no
propagation delay or length is reported and there is no comparison
with any threshold.
Note: For 1Gbps, both MDI and MDIX can be reported simultaneously since
crossed pairs detection is performed independently for pairs A-B and C-D.
Vista de pagina 211
1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 261 262

Comentarios a estos manuales

Sin comentarios