
Traffic Generation & Monitoring
Ethernet Test Set 125
Global Configuration
Global Configuration
The Global page allows configuring the main stream properties and global
test parameters such as duration and rate unit.
Press , select Traffic Generation & Monitoring, Stream Config, and
the Global tab.
³ Rate Unit: Select the unit for the transmission and receive rate.
Choices are Mbps and %. The default setting is Mbps.
³ Duration: Set the duration of the
test. The choices are as follows:.
³ 15-Min
³ 1-Hour
³ 2-Hours
³ 4-Hours
³ 6-Hours
³ 12-Hours
³ 24-Hours
³ User Defined
³ Disabled: Runs the test for infinite time. It can be stopped
manually at any point of time.
The default value is Disabled. Select the duration field next to User
Defined and a pop up menu will be displayed to configure the test
duration.
³ TX: Enable or disable main stream transmission. The default value is
Enabled.
³ Framing: Select the frame structure of the main stream. Choices are
Ethernet/IPv4/UDP or Ethernet/IPv6/UDP and Ethernet. The default
setting is Ethernet.
Comentarios a estos manuales