Exfo FTB-800 Series for FTB-1 Manual de usuario descargar pdf (Pagina 242)

100

101

Test Setup - Test Configurator, Timer, and System

232 FTB-700G/800 Series

TCP Throughput

From the Test menu, tap Setup, Test Configurator, and tap on the test

block.

TCP Mode

Since two units are required to perform a TCP Throughput test, one unit

must be the source (Local) unit and the other one the destination

(Remote). Set the TCP Mode on both units: Local (default) or Remote.

TCP Connection Configuration

 Remote IP Address, available with Local TCP mode, allows to enter

the IP address of the remote unit.

 Quick Ping button automatically starts the quick Ping utility for the

remote IP address and provides either a successful or failed result. The

quick Ping uses 3 attempts, a Delay of 1 second, a Timeout of 2

seconds, and a Data Size of 32 Bytes. Refer to Ping & Trace Route on

page 436 for more options.

 Accept Connection from IP, available with Remote TCP mode, allows

to enter the IP address of the local unit. The IP address 0.0.0.0 (default)

listens to any TCP stream.

 IP TOS/DS, available with Local TCP mode, is configurable from

0x00 (default) to 0xFF.

 TCP Port, available with Local and Remote TCP modes, allows the

selection of the TCP port number: 0 to 65535 (default is 50201). For the

local unit, the specified TCP port will be used for the TCP initialization

algorithm with the remote unit. The following TCP segments sent by

the local unit will use the TCP port number replied by the remote unit.

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 620 621

Comentarios a estos manuales

Sin comentarios

Exfo FTB-800 Series for FTB-1 Manual de usuario Pagina 242

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FTB-800 Series for FTB-1