Exfo FTB-800 Series for FTB-1 Manual de usuario Pagina 199

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 621
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 198
Test Setup - Test Configurator, Timer, and System
NetBlazer 189
Services - Global
Frame Size
1
indicates the frame size of each service. Tap on the Frame
Size button to modify the frame size of each service.
Framing indicates the framing of each service. Tap on the Framing
button to modify the Frame Format, Network Layer, Transport Layer,
VLAN (see Modify Frame Structure from the MAC/IP/UDP on
page 151).
VLAN (ID/Priority) indicates the ID and Priority of each VLAN level for
each service. Tap on the VLAN button to modify the VLAN settings (see
VLAN from the MAC/IP/UDP on page 151).
Addressing indicates the source and destination IP addresses for each
services. Tap on the Addressing button to modify the addressing (see
MAC and IP from the MAC/IP/UDP on page 151).
SLA Button
The SLA parameters are displayed and configurable per service. Click on
the desired column button to access the configuration settings.
See General Button on page 188 for more information on check boxes,
Direction, and Service Name.
See SLA Parameters on page 196 for more information on CIR, CIR+EIR,
CBS, EBS, Max Jitter, Max Latency, and Frame Loss.
Total TX Rate
Note: Only available when the Service Performance Test check box is selected
(see EtherSAM - Global on page 120). For Dual Test Set, the total TX rates
are displayed for both Local and Remote directions.
Committed displays the total enabled TX rate (bandwidth) that will be
generated by the selected service(s).
Available displays the total TX rate (bandwidth) available for traffic
generation.
Vista de pagina 198
1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 620 621

Comentarios a estos manuales

Sin comentarios