Exfo IQS-12002B Calibration System Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 108
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Getting Started with Your Calibration System
12 IQS-12002B
Inserting and Removing Test Modules
4. Insert the protruding edges of the module into the grooves of the unit’s
module slot.
5. Push the module all the way to the back of the slot, until the retaining
screw makes contact with the unit casing.
6. While applying slight pressure to the module, turn the retaining screw
knob (located at the bottom of the panel) clockwise until the knob is
horizontal. This will secure the module into its “seated” position.
The module is correctly inserted when its front panel is flush with the front
panel of the controller or expansion unit.
Retaining screw
Retaining screw knob
Protruding edges
(right side of module)
5
6
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 107 108

Comentarios a estos manuales

Sin comentarios