Exfo FLS-2600B Tunable Laser Source Manual de usuario Pagina 79

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 157
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 78
Tunable Laser Source 71
C Remote Control
Your Tunable Laser Source can be remotely controlled by either the
GPIB interface (through a GPIB cable connected to the GPIB port), or
RS-232 interface (through a serial cable connected to the serial port).
The commands used in both protocols are the same and described in the
following pages. When the FLS-2600B is being remotely controlled by
GPIB, Remote appears in the upper right-hand corner of the display.
Note: If you have already designed a GPIB program to control a Tunable Laser
Source from EXFO’s IQS Series (IQS-2600B), you can reuse sections for the
FLS-2600B.
Setting the FLS-2600B for Remote Control
To remotely control the FLS-2600B, you need to set a GPIB address or
activate the RS-232 port.
To set the remote control mode:
1. Press Setup.
2. Turn the selection dial clockwise until REMOTE is displayed.
The current setting appears.
Edit
Vista de pagina 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 156 157

Comentarios a estos manuales

Sin comentarios