
OSA/OCA 7
3 Getting Started with Your
OSA/OCA
Inserting and Removing Test Modules
To insert a module into the FTB-5230S/-OCA:
1. Exit ToolBox and turn off your unit.
2. Position the FTB-500 so that its right panel is facing you.
CAUTION
Never insert or remove a module while the FTB-500 is turned on.
This will result in immediate and irreparable damage to both the
module and unit.
CAUTION
To avoid damaging your unit, use it only with modules approved by
EXFO.
WARNING
When the laser safety LED ( ) is flashing on the FTB-500, at least
one of your modules is emitting an optical signal. Please check all
modules, as it might not be the one you are currently using.
Comentarios a estos manuales