Exfo FLS-2200 Broadband Source Manual de usuario descargar pdf (Pagina 171)

SCPI-Based Errors

Broadband Source 163

–312 “PUD memory lost” Indicates that the protected user data saved by the

*PUD command has been lost.

–313 “Calibration memory

lost”

Indicates that nonvolatile calibration data used by

the *CAL? command has been lost.

–314 “Save/Recall memory

lost”

Indicates that the nonvolatile data saved by the

*SAV? command has been lost.

–315 “Configuration

memory lost”

Indicates that nonvolatile configuration data saved

by the device has been lost. The meaning of this

error is device-specific.

–320 “Storage fault” Indicates that the firmware detected a fault when

using data storage. This error is not an indication of

physical damage or failure of any mass storage

element.

–321 “Out of memory” An internal operation required more memory than

was available.

–330 “Self-test failed” -----

–340 “Calibration failed” -----

–350 “Queue overflow” A specific code entered into the queue in lieu of

the code that caused the error. This code indicates

that there is no room in the queue and an error

occurred but was not recorded.

–360 “Communication

error”

This is the generic communication error for

devices that cannot detect the more specific errors

described for errors –361 through –363.

–361 “Parity error in program

message”

Parity bit not correct when data received, for

example, on a serial port.

–362 “Framing error in

program message”

A stop bit was not detected when data was

received for example, on a serial port (for example,

a baud rate mismatch).

Error

Number

Description Probable Cause

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 182 183

Comentarios a estos manuales

Sin comentarios

Exfo FLS-2200 Broadband Source Manual de usuario Pagina 171

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FLS-2200 Broadband Source