Exfo AXS-100 Series OTDR Manual de usuario descargar pdf (Pagina 84)

Using Your OTDR as a Light Source

76 AXS-100 Series

Activating/Deactivating a Light Source

The Power Meter pane remains displayed when

you use the source.

The source status is indicated with a LED in the

status bar and with the Active indicator under the

keypad.

Note: The Active indicator always shows the source,

VFL, or OTDR port status (even in FIP or idle mode).

To activate the light source:

1. Connect the fiber under test to the source port (see Cleaning and

Connecting Optical Fibers on page 22).

If your unit is equipped with two OTDR ports, ensure that you connect

the fiber to the appropriate port, depending on the wavelength you

intend to use.

2. Press Menu, select Source, and then press Enter.

3. Press Wavelength (F1/F2 key) to activate each available source in turn.

Use the arrows to open the wavelength/status list and select the

desired wavelength.

To deactivate the light source:

Press Wavelength (F1/F2 key) until you get past the last source. The list

displays Off.

Use the arrows to open the wavelength list and select Off.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 154 155

Sin comentarios

Exfo AXS-100 Series OTDR Manual de usuario Pagina 84