
Operating Your RTU in OTDR Measuring Mode
Fiber Guardian 173
Performing a Test
Performing a Test
You can perform a test for optical routes that the RTU has created. This type
of test is performed on a specific test setup. It is similar to a test program,
except that it is not “scheduled” at a later time.
Only the test setups for which a reference has been created can be used to
perform a test. For information on references, see Creating the Reference
Traces on page 160.
You can also start a test from the current fault list window (see Viewing the
Current Fault List on page 199).
Comentarios a estos manuales