Exfo VDSL2 Manual de usuario Pagina 162

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 267
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 161
Configure Tests for DSL/IP Triple-Play Verification
154 AXS-200/635
Configure DSL/IP Tests
Ping Test
The Ping Test tab allows you to configure the parameters to perform a ping
test, also known as an ICMP echo request, during the CPE test.
The available parameters are the
following:
³ IP Address lists either the URL or
IP Address where the unit pings.
³ URL/IP Address is the destination
IP address of the device actively
connected to the network.
³ Packet Size is a value from
32 through 1200 of the number of bytes sent in one packet. The default
value is 32.
³ Total Pings is the total number of ping packets to send out from
1 through 99. The default value is 3.
³ Timeout is the time in seconds from 1 through 15, that the unit will
wait for a response back from the destination device. The default value
is 1.
³ Max hops is the number of hops from 1 through 99, that the unit will
attempt to reach a destination IP address. The default value is 32.
To select the ping parameters to configure:
1. Press the up/down arrows to select the desired parameter.
2. Press to open the list or modify the parameter.
3. In the list, press the up/down arrows to select the function or mode.
OR
Use the alphanumeric keypad to enter the value you want to specify.
4. Press to confirm the selection.
Vista de pagina 161
1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 266 267

Comentarios a estos manuales

Sin comentarios