Exfo PM-1600 High-Speed Power Meter Manual de usuario Pagina 129

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 128
Remote Control (SCPI) Commands
High-Speed Power Meter 119
Specific Commands
FORMat:READings[:DATA]
Description This command changes the resolution of the displayed power
value when dB or dBm is selected (for the selected channel
when using a PM-1620). If this command is sent while an
acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax FORM:READ[:DATA]<space><digits>
Parameters The <digits> parameter can be
“0”- no digits after the decimal point
“1”- one digit after the decimal point
“2”- two digits after the decimal point
“3”- three digits after the decimal point
“4”- four digits after the decimal point
“5”- auto-resolution, determined by the measured power level
Example FORM:READ:DATA 3
Remote Control (SCPI) Commands
High-Speed Power Meter 119
Specific Commands
FORMat:READings[:DATA]
Description This command changes the resolution of the displayed power
value when dB or dBm is selected (for the selected channel
when using a PM-1620). If this command is sent while an
acquisition is in progress, the “Acquisition already running”
error message will be raised.
Syntax FORM:READ[:DATA]<space><digits>
Parameters The <digits> parameter can be
“0”- no digits after the decimal point
“1”- one digit after the decimal point
“2”- two digits after the decimal point
“3”- three digits after the decimal point
“4”- four digits after the decimal point
“5”- auto-resolution, determined by the measured power level
Example FORM:READ:DATA 3
Vista de pagina 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 161 162

Comentarios a estos manuales

Sin comentarios