Exfo FastReporter 2 Manual de usuario descargar pdf (Pagina 257)

100

101

Working with iOLM files

Post Processing Software 247

Customizing the Elements Table Tab

To change the launch fiber and receive fiber positions:

1. Open the iOLM file.

2. Enter the launch fiber length and receive fiber length in the Test

Settings table under the Summary tab.

When the launch fiber length and receive fiber length are changed, a

partial analysis is performed. In this partial analysis, the values for link

length, link loss, link ORL, element position, element section length, and

diagnostics are recalculated. This partial analysis does not change the

elements you have added or the elements you have changed in the link.

Note: If the entered launch fiber length and receive fiber length are not valid, the

application prompts an error message. If no element is present at the

position, then a new element is automatically inserted in that place.

Note: If a macrobend is set either as link start or link end, a new connector is

added and that element will be set as link start or link end.

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 395 396

Comentarios a estos manuales

Sin comentarios

Exfo FastReporter 2 Manual de usuario Pagina 257

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FastReporter 2