Exfo ETS-1000 Manual de usuario descargar pdf (Pagina 28)

Setting up your Unit

20 ETS-1000

Interface setup

 Autoneg: enabling the auto-negotiation mode. If enabled, you need to

select the preferable rate (or set Automatic, any of the

10/100/1000Mbit/s values that can be used) and set the

Auto-negotiation parameter to On. The connection will be established

only if the auto-negotiation mode is enabled also on remote end, and

at least one of the parameters is set to the same value.

 MAC address: MAC address of the port (A, B, or LAN), which can be

specified.

 VLAN: Enabling/Disabling VLAN parameters setup.

 ID: 12-bit VLAN identifier (integer in the range 0–4095).

 Priority: traffic priority.

 MPLS: switch to the MPLS. Interface A menu (MPLS. Interface B).

Note: if you use SFP-modules, then the Speed should be always set to the 1Gb/s

value.

 Transmission: switch to the Label stack menu.

 Reception: switch to the Reception rules menu.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 172 173

Sin comentarios

Exfo ETS-1000 Manual de usuario Pagina 28