Exfo FTB-8100 Series Transport Blazer for FTB-500 Manual de usuario descargar pdf (Pagina 275)

100

101

SONET Tabs

SONET/SDH Application 261

LOP TX (SONET)

For Continuous method:

³ On/Off button: The On/Off button is used to activate/deactivate the

selected alarm. This setting is disabled (Off) by default.

For Burst method:

The burst method injects the programmed number of consecutive alarmed

frames, reprensenting the burst Duration (M), over a specific event

Period (N).

³ Duration and Unit: Select the number of consecutive alarmed frames

or the number of consecutive seconds in alarm.

³ Mode: Allows the selection of the burst mode that will determine if the

burst will be repeated (Repeat) at the beginning of each period or not

(Single).

³ Period and Unit: When the Mode is set to Repeat, select the interval,

either in frames or in seconds, the alarm burst will be repeated.

³ On/Off button: The On/Off button is used to activate/deactivate the

selected alarm for the selected Duration and Period. For Single Mode,

the alarm generation will be active for the specified duration and will

automatically stop (the On/Off button turns Off). For Repeat Mode the

alarm generation will be active for the specified duration and will be

repeated continuously at the beginning of each period until the On/Off

button is turned Off. This setting is disabled (Off) by default.

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 718 719

Comentarios a estos manuales

Sin comentarios

Exfo FTB-8100 Series Transport Blazer for FTB-500 Manual de usuario Pagina 275

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Exfo FTB-8100 Series Transport Blazer for FTB-500